Click here

FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

Click here
Click here
  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See PageClick here).

  2. Click here

    REMOVE FRONT DOOR SCUFF PLATE


    1. A017B6P

      Disengage the 8 claws and guide, and remove the front door scuff plate LH.

  3. Click here

    DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

  4. Click here

    REMOVE REAR DOOR SCUFF PLATE


    1. A017D4T

      Disengage the 5 claws, 3 clips and guide, and remove the rear door scuff plate LH.

  5. Click here

    DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

  6. Click here

    REMOVE LOWER CENTER PILLAR GARNISH


    1. A017F82

      Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.

  7. Click here

    DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A017G6U

      Remove the bolt and disconnect the floor end of the front seat outer belt assembly.

  8. Click here

    REMOVE CENTER PILLAR GARNISH


    1. A017B73

      Remove the screw and clip.

    2. Disengage the 2 guides and clip, and remove the center pillar garnish LH.

  9. Click here

    REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A017D0I

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A017FB8

      Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tip:

      Tape the screwdriver tip before use.

    3. A017BRL

      Remove the 2 bolts and front seat outer belt assembly.

  10. Click here

    REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A017DPK

      Remove the 2 bolts and front shoulder belt anchor adjuster assembly.