Click here

SEAT BELT WARNING SYSTEM Driver Side Seat Belt Warning Light does not Operate

Click here
Click here
DTC Code DTC Name
  Driver Side Seat Belt Warning Light does not Operate
Click here

DESCRIPTION

When the ignition switch is on (IG), the center airbag sensor assembly transmits front seat inner belt state signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the driver seat belt warning light. If the seat belt is fastened, the warning light goes off.

Note:

The seat belt warning system uses CAN. Before troubleshooting the seat belt warning system, perform "COMMUNICATION FUNCTION CHECK" by following "HOW TO PROCEED WITH TROUBLESHOOTING" to confirm that the communication systems are normal.

A017EY3E06
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK FOR DTCs


    1. Check for DTCs.

      Result
      Result Proceed to
      Output DTC (CAN communication) A
      Output DTC (Airbag system) B
      No output DTC C

  2. Click here

    PERFORM ACTIVE TEST USING INTELLIGENT TESTER


    1. Operate the intelligent tester according to the steps on the display and select "ACTIVE TEST".

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Driver Side Seat Belt Driver side seat belt warning light Driver side seat belt warning light is OFF / ON Confirm that the vehicle is stopped, engine idling
      OK
      Switch condition (ON/OFF) can be switched by "ACTIVE TEST".

  3. Click here

    GO TO CAN COMMUNICATION SYSTEMClick here

  4. Click here

    GO TO AIRBAG SYSTEMClick here

  5. Click here

    REPLACE COMBINATION METER ASSEMBLYClick here

  6. Click here

    END