CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the battery negative (-) cable is disconnected.

      CAUTION:

      Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

    3. Temporarily install the curtain shield airbag assembly to the body panel with the 11 hooks.

      Note

      Do not twist the curtain shield airbag assembly when installing it.

    4. Install 11 new bolts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

      A017CURE01

    5. Connect the curtain shield airbag connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

      A017C0O

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.