Click here

DRIVER SIDE KNEE AIRBAG ASSEMBLY INSTALLATION

Click here
Click here
  1. Click here

    INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the battery negative (-) cable is disconnected.

      CAUTION:

      Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

    3. A017F8J

      Install the DLC3 to the driver side knee airbag assembly with the 2 claws.

    4. A017EBJ

      Connect the connector to the driver side knee airbag assembly.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

    5. A017EHS

      Support the driver side knee airbag assembly with one hand as shown in the illustration.

    6. A017CTB

      Temporarily install the driver side knee airbag assembly with the 2 hooks.

    7. A017FEG

      Install the driver side knee airbag assembly with the 4 bolts.

      10 N*m 102 kgf*cm 7 ft.*lbf
  2. Click here

    INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)


    1. A017BY3

      Connect the hood lock control cable assembly.

    2. Connect each connector.

    3. Engage the 3 claws and 10 clips.

    4. Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.

  3. Click here

    INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)


    1. A017CWD

      Connect the hood lock control cable assembly.

    2. Connect each connector and the aspirator duct.

    3. A017EU2

      Engage the 3 claws and 10 clips.

    4. Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.

  4. Click here

    INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH


    1. A017G63

      Engage the claw and clip, install the cowl side trim sub-assembly LH.

    2. Install the clip.

  5. Click here

    INSTALL FRONT DOOR SCUFF PLATE LH


    1. A017B6P

      Engage the guide and 8 claws, and install the front door scuff plate LH.

  6. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See PageClick here).

  7. Click here

    INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light (Click here).