FRONT AIRBAG SENSOR INSTALLATION


  1. INSTALL FRONT AIRBAG SENSOR


    1. Check that the ignition switch is off.

    2. Check that the battery negative (-) cable is disconnected.

      CAUTION:

      Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

    3. A017BN5

      Temporarily install the front airbag sensor with the 2 claws and pin.

    4. Install the front airbag sensor with the 2 bolts.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

      • Make sure that the pin is securely inserted into the body hole.

      • Tighten the bolt while holding the front airbag sensor because the front airbag sensor claws and pin (stopper) are easily damaged.

    5. Check that there are no loose parts after installing the front airbag sensor.

    6. Connect the connector to the front airbag sensor.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL HEADLIGHT ASSEMBLY


    1. Connect the connectors and engage the clamp.

    2. Engage the claw and install the headlight assembly with the bolt and 2 screws.

      Torque:
      3.6 N*m  { 37 kgf*cm, 32 in.*lbf }
    3. A017FX5

      Engage the guide as shown in the illustration.

  3. INSTALL FRONT BUMPER ASSEMBLY


    1. Connect each fog light connector, and then install the front bumper assembly.

    2. A017E0P

      Engage the 5 claws.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. Install the 3 clips and 8 screws.

    4. A017D06E01
      Text in Illustration
      *1 Correct
      *2 Incorrect

      Install the screw and 2 pin hold clips.

      Note

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  4. INSTALL RADIATOR GRILLE SUB-ASSEMBLY


    1. A017F4G

      Engage the 2 guides and 8 claws, and install the radiator grille sub-assembly.

    2. Install the 6 clips.

  5. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 11 clips.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSPECT AND ADJUST HEADLIGHT AIMING

    Click here

  8. INSPECT AND ADJUST FOG LIGHT AIMING

    Click here

  9. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.