AIRBAG SYSTEM, Diagnostic DTC:B1610/13

Click here

DESCRIPTION

The front airbag sensor RH circuit consists of the center airbag sensor assembly and front airbag sensor RH.

The front airbag sensor RH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the airbag should be deployed.

DTC B1610/13 is recorded when a malfunction is detected in the front airbag sensor RH.

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE

1. Click here

   CHECK FRONT AIRBAG SENSOR RH

   
   
   1. 

      Turn the ignition switch off.

   2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

   3. Interchange the front airbag sensor LH with RH and connect the connectors to them.

   4. Connect the negative (-) terminal cable to the battery.

   5. Turn the ignition switch on (IG), and wait for at least 60 seconds.

   6. Clear the DTCs stored in the memory (Click here).

   7. Turn the ignition switch off.

   8. Turn the ignition switch on (IG), and wait for at least 60 seconds.

   9. Check for DTCs (Click here).

      Result
      Result Proceed to DTCs B1610/13 and B1615/14 are not output A DTC B1610/13 is output B DTC B1615/14 is output C

      Tip:

      Codes other than DTCs B1610/13 and B1615/14 may be output at this time, but they are not related to this check.

   
   
   • AClick here
   • BClick here
   • CClick here
2. Click here

   REPLACE CENTER AIRBAG SENSOR ASSEMBLYClick here

3. Click here

   REPLACE FRONT AIRBAG SENSOR RHClick here

4. Click here

   USE SIMULATION METHOD TO CHECKClick here