Click here

FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

Click here
Click here
  1. Click here

    INSTALL NO. 1 COOLER THERMISTOR


    1. A017C7UE01

      Install No. 1 cooler thermistor as shown in the illustration.

      Part Length
      A 34.3 mm 1.35 in.
      B 20.9 mm 0.82 in.
      C 50 mm 1.96 in.
      Note:

      • Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

      • When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).

      • After inserting the thermistor, do not apply excessive force to the wire.

      • Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".

  2. Click here

    INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    1. A017F5W

      Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces.

    2. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

      Compressor oil
      ND-OIL 8 or equivalent
    3. A017EGL

      Install the No. 1 cooler evaporator sub-assembly.

    4. Engage the clamp.

    5. A017B5I

      Engage the 5 claws.

    6. Install the plate cover with the 6 screws.

    7. Connect the connector.

  3. Click here

    INSTALL COOLER EXPANSION VALVE


    1. A017FGQ

      Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

      3.5 N*m 36 kgf*cm 31 in.*lbf
  4. Click here

    INSTALL BLOWER ASSEMBLY


    1. A017BS3

      Engage the 2 claws.

    2. Install the blower assembly with the 2 screws.

    3. Connect the connector.

  5. Click here

    INSTALL AIR CONDITIONING UNIT

    (Click here)