DESCRIPTION
This DTC is output there is an open, short or ECU communication malfunction between the main body ECU and certification ECU.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2287 | There is an open, short or ECU communication malfunction between main body ECU and certification ECU. |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
Note
When using the intelligent tester with the engine switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
Tech Tips
When DTC B2287 and B2785 are output simultaneously, perform the troubleshooting for DTC B2785 first Click here.
PROCEDURE
CLEAR DTC
Delete the DTC Click here.
| NEXT |
|
CHECK FOR DTC
Recheck for DTC Click here.
| Result | Proceed to |
|---|---|
| DTC B2287 output reoccurs | A |
| DTC B2287 output does not reoccur | B |
| B |
|
USE SIMULATION METHOD TO CHECK Click here |
| A |
|
CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - MAIN BODY ECU)
Disconnect the L15 and DA ECU connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Standard resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| Standard voltage | ||||||
|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
REPLACE MAIN BODY ECU
Temporarily replace the main body ECU with a new or normally functioning one.
| NEXT |
|
CHECK FOR DTC
Delete the DTC Click here.
Recheck for DTC Click here.
| Result | Proceed to |
|---|---|
| DTC B2287 output does not reoccur | A |
| DTC B2287 output reoccurs | B |
| B |
|
REPLACE CERTIFICATION ECU |
| A |
|
REPLACE MAIN BODY ECU