REAR DOOR SUNSHADE ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR CURTAIN SUB-ASSEMBLY LH


    1. for Standard Body:


      1. Connect the connector.

      2. Attach the 3 clips to install the rear curtain sub-assembly LH.

      3. Install the 10 screws.

    2. for Long Body:


      1. Connect the connector.

      2. Attach the 4 clips to install the rear curtain sub-assembly LH.

      3. Install the 10 screws.

  2. INSTALL REAR DOOR NO. 2 FRAME GARNISH LH


    1. Attach the claws and install the rear door No. 2 frame garnish LH.

  3. INSTALL REAR DOOR FRAME GARNISH LH


    1. w/o Rear Door Sunshade:


      1. Attach the claws.

      2. Attach the clip to install the rear door frame garnish LH with screw.

    2. w/ Rear Door Sunshade:


      1. Attach the claws.

      2. Attach the 2 clips to install the rear door frame garnish LH.

  4. INSTALL REAR DOOR TRIM COVER LH


    1. Attach the 5 clips to install the rear door trim cover LH.

    2. Install the cushion.

  5. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. for Long Body:


      1. A01GNLN

        Connect the 2 cables to the inside handle.

      2. Connect the connector.

      3. Install the rear door trim board sub-assembly LH with the 3 screws and 14 clips.

    2. for Standard Body:


      1. A01GNLN

        Connect the 2 cables to the inside handle.

      2. Connect the connector.

      3. Install the rear door trim board sub-assembly LH with the 3 screws and 12 clips.

  6. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH

    A01GI8G

    1. Install the illumination light with the screw.

    2. Connect the connector.

    3. Attach the 2 clips to install the rear rear power window regulator switch assembly with rear door armrest base panel.

  7. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    1. Attach the 3 claws to install the rear door inside handle bezel plug LH.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      for LHD:

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

    2. A01GI9P

      for RHD:

      Install the 6 clips and cowl top ventilator louver LH.

      Note

      If the cowl top ventilator louver LH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver LH is installed properly.

  10. PERFORM INITIALIZATION

    Click here

  11. INSPECT REAR DOOR SUNSHADE SYSTEM

    Click here