REAR POWER SEAT CONTROL SYSTEM DATA LIST / ACTIVE TEST
-
READ DATA LIST
Tech Tips
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
-
Warm up the engine.
-
Turn the engine switch off.
-
Connect the intelligent tester to the DLC3.
-
Turn the engine switch on (IG).
-
Turn the intelligent tester on.
-
Enter the following menus: Body / (desired system) / Data List.
-
According to the display on intelligent tester, read the "Data List".
Rear Left Seat Tester Display Measurement Item/Range Normal Condition Diagnostic Note Seat Memory No1 Seat position memorized with seat memory switch M / MEM or NOT MEM MEM: Memorized
NOT MEM: Not memorized
- Door OP Link Return Set Door open linked return operation / Operate or Not Opr Operate: Rear door open
Not Opr: Rear door closed
- RR-Door Courtesy Door courtesy switch signal / ON or OFF ON: Rear LH side door is open
OFF: Rear LH side door is closed
- Ignition Switch Engine switch status / ON or OFF ON: Engine switch on (IG)
OFF: Engine switch off
"OFF" is also displayed for this item when the engine switch is on (ACC). SET Switch Seat memory set switch signal / ON or OFF ON: Memory set switch is ON
OFF: Memory set switch is OFF
- M1 Switch Seat memory switch M signal / ON or OFF ON: Seat memory switch M is ON
OFF: Seat memory switch M is OFF
- Slide Position Seat sliding position / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Steering Position Info Steering wheel position /RHD, LHD or LHD RHD: RHD vehicle
LHD: LHD vehicle
- RL-Door Courtesy Door courtesy switch signal / ON or OFF ON: Rear RL side door is open
OFF: Rear RL side door is closed
- Reclining Position* Seatback position / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Reclining Position Init Flg* Reclining initialization flag / ON or OFF ON: Completed
OFF: Not completed
- OTTOMAN initialize Flag* Ottoman initialization flag / ON or OFF ON: Completed
OFF: Not completed
- Reclining Position Front Limit* Reclining front position limit / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Reclining Position Rear Limit* Reclining rear position limit / MIN: 0, MAX: 65535 Within range from 0 to 65535 - OTTOMAN UP Most position* Ottoman upper position limit / MIN: 0, MAX: 65535 Within range from 0 to 65535 - OTTOMAN Down Most position* Ottoman lower position limit / MIN: 0, MAX: 65535 Within range from 0 to 65535 - OTMAN Position* Ottoman position / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Ottoman Position Mem No1*
OTMAN position Memory No1*
Ottoman position memorized with seat memory switch M / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Ottoman Up* Ottoman switch signal (Upward) / ON or OFF ON: Ottoman switch (Upward) is ON
OFF: Ottoman switch (Upward) is OFF
- Ottoman Down* Ottoman switch signal (Downward) / ON or OFF ON: Ottoman switch (Downward) is ON
OFF: Ottoman switch (Downward) is OFF
- Reclining Front* Reclining switch signal (Forward) / ON or OFF ON: Reclining switch (Forward) is ON
OFF: Reclining switch (Forward) is OFF
- Reclining Rear* Reclining switch signal (Rearward) / ON or OFF ON: Reclining switch (Rearward) is ON
OFF: Reclining switch (Rearward) is OFF
- P Seat Slide Position* Passenger seat slide position information / MIN: 0, MAX: 15 Within range from 0 to 15 - P Seat Position* Passenger seat reclining position information / MIN: 0, MAX: 15 Within range from 0 to 15 - P Seat Slide Prohibit* Rear ottoman operation during passenger seat sliding / Permit or Prohibit Permit: Permitted
Prohibit: Prohibited
- P Seat Reclining Prohibit* Rear ottoman operation during passenger seat reclining / Permit or Prohibit Permit: Permitted
Prohibit: Prohibited
- Ottoman Status* Ottoman position information / Storage or In use Storage: Ottoman in stored position
In use: Ottoman being used
- Rear Seat Initialize Rear seat initialization information / Init or No Init Init: Initialization completed
No Init: Initialization not yet performed
- Rear Right Seat Tester Display Measurement Item/Range Normal Condition Diagnostic Note Seat Memory No1 Seat position memorized with seat memory switch M / MEM or NOT MEM MEM: Memorized
NOT MEM: Not memorized
- Door OP Link Return Set Door open linked return operation / Operate or Not Opr Operate: Rear door open
Not Opr: Rear door closed
- RR-Door Courtesy Door courtesy switch signal / ON or OFF ON: Rear RH side door is open
OFF: Rear RH side door is closed
- Ignition Switch Engine switch status / ON or OFF ON: Engine switch on (IG)
OFF: Engine switch off
"OFF" is also displayed for this item when the engine switch is on (ACC). SET Switch Seat memory set switch signal / ON or OFF ON: Memory set switch is ON
OFF: Memory set switch is OFF
- M1 Switch Seat memory switch M signal / ON or OFF ON: Seat memory switch M is ON
OFF: Seat memory switch M is OFF
- Slide Position Seat sliding position / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Steering Position Info Steering wheel position /RHD, LHD or LHD RHD: RHD vehicle
LHD: LHD vehicle
- RL-Door Courtesy Door courtesy switch signal / ON or OFF ON: Rear RL side door is open
OFF: Rear RL side door is closed
- Reclining Position* Seatback position / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Reclining Position Init Flg* Reclining initialization flag / ON or OFF ON: Completed
OFF: Not completed
- OTTOMAN initialize Flag* Ottoman initialization flag / ON or OFF ON: Completed
OFF: Not completed
- Reclining Position Front Limit* Reclining front position limit / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Reclining Position Rear Limit* Reclining rear position limit / MIN: 0, MAX: 65535 Within range from 0 to 65535 - OTTOMAN UP Most position* Ottoman upper position limit / MIN: 0, MAX: 65535 Within range from 0 to 65535 - OTTOMAN Down Most position* Ottoman lower position limit / MIN: 0, MAX: 65535 Within range from 0 to 65535 - OTMAN Position* Ottoman position / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Ottoman Position Mem No1*
OTMAN position Memory No1*
Ottoman position memorized with seat memory switch M / MIN: 0, MAX: 65535 Within range from 0 to 65535 - Ottoman Up* Ottoman switch signal (Upward) / ON or OFF ON: Ottoman switch (Upward) is ON
OFF: Ottoman switch (Upward) is OFF
- Ottoman Down* Ottoman switch signal (Downward) / ON or OFF ON: Ottoman switch (Downward) is ON
OFF: Ottoman switch (Downward) is OFF
- Reclining Front* Reclining switch signal (Forward) / ON or OFF ON: Reclining switch (Forward) is ON
OFF: Reclining switch (Forward) is OFF
- Reclining Rear* Reclining switch signal (Rearward) / ON or OFF ON: Reclining switch (Rearward) is ON
OFF: Reclining switch (Rearward) is OFF
- P Seat Slide Position* Passenger seat slide position information / MIN: 0, MAX: 15 Within range from 0 to 15 - P Seat Position* Passenger seat reclining position information / MIN: 0, MAX: 15 Within range from 0 to 15 - P Seat Slide Prohibit* Rear ottoman operation during passenger seat sliding / Permit or Prohibit Permit: Permitted
Prohibit: Prohibited
- P Seat Reclining Prohibit* Rear ottoman operation during passenger seat reclining / Permit or Prohibit Permit: Permitted
Prohibit: Prohibited
- Ottoman Status* Ottoman position information / Storage or In use Storage: Ottoman in stored position
In use: Ottoman being used
- Rear Seat Initialize Rear seat initialization information / Init or No Init Init: Initialization completed
No Init: Initialization not yet performed
- Rear Console Switch Tester Display Measurement Item/Range Normal Condition Diagnostic Note R/L Selection SW Right SW Right / left selection switch signal (Right switch) / NOT SEL or R SEL NOT SEL: Selection switch (Right switch) is OFF
R SEL: Selection switch (Right switch) is ON
- R/L Selection SW Left SW Right / left selection switch signal (Left switch) / NOT SEL or L SEL NOT SEL: Selection switch (Left switch) is OFF
L SEL: Selection switch (Left switch) is ON
- Rear Seat Slide Front SW Sliding switch signal (Forward) / ON or OFF ON: Sliding switch (Forward) is ON
OFF: Sliding switch (Forward) is OFF
- Rear Seat Slide Back SW Sliding switch signal (Rearward) / ON or OFF ON: Sliding switch (Rearward) is ON
OFF: Sliding switch (Rearward) is OFF
- Rear Seat Headrest Up SW Headrest switch signal (Upward) / ON or OFF ON: Headrest switch (Upward) is ON
OFF: Headrest switch (Upward) is OFF
- Rear Seat Headrest Down SW Headrest switch signal (Downward) / ON or OFF ON: Headrest switch (Downward) is ON
OFF: Headrest switch (Downward) is OFF
- Rear Seat Hollow Front SW Upper lumbar switch signal (Forward) / ON or OFF ON: Upper lumbar switch (Forward) is ON
OFF: Upper lumbar switch (Forward) is OFF
- Rear Seat Hollow Back SW Upper lumbar switch signal (Rearward) / ON or OFF ON: Upper lumbar switch (Rearward) is ON
OFF: Upper lumbar switch (Rearward) is OFF
- Rear Seat Reclining Front SW* Reclining switch signal (Forward) / ON or OFF ON: Reclining switch (Forward) is ON
OFF: Reclining switch (Forward) is OFF
- Rear Seat Reclining Back SW* Reclining switch signal (Rearward) / ON or OFF ON: Reclining switch (Rearward) is ON
OFF: Reclining switch (Rearward) is OFF
- Rear Seat Ottoman Up SW* Ottoman switch signal (Upward) / ON or OFF ON: Ottoman switch (Upward) is ON
OFF: Ottoman switch (Upward) is OFF
- Rear Seat Ottoman Down SW* Ottoman switch signal (Downward) / ON or OFF ON: Ottoman switch (Downward) is ON
OFF: Ottoman switch (Downward) is OFF
-
-
*: w/ Ottoman
-
-
-
PERFORM ACTIVE TEST
Tech Tips
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
-
Warm up the engine.
-
Turn the engine switch off.
-
Connect the intelligent tester to the DLC3.
-
Turn the engine switch on (IG).
-
Turn the intelligent tester on.
-
Enter the following menus: Body / (desired system) / Active Test.
-
According to the display on intelligent tester, perform the "Active Test".
Rear Left Seat Tester Display Test Part Control Range Seat Slide Operation Seat sliding operation FRONT / REAR Headrest Operation Seat headrest operation UP / DOWN Rear Seat Lumbar Adjustment Seat lumbar operation FRONT / REAR Seat Reclining* Seat reclining operation FRONT / REAR Ottoman* Seat ottoman operation UP / DOWN
-
*: w/ Ottoman
Rear Right Seat Tester Display Test Part Control Range Seat Slide Operation Seat sliding operation FRONT / REAR Headrest Operation Seat headrest operation UP / DOWN Rear Seat Lumbar Adjustment Seat lumbar operation FRONT / REAR Seat Reclining* Seat reclining operation FRONT / REAR Ottoman* Seat ottoman operation UP / DOWN
-
*: w/ Ottoman
-
-