FRONT POWER SEAT CONTROL SYSTEM Power Seat Power Easy Access System Function does not Operate

DESCRIPTION

When the engine switch is off and the shift lever is in P, the power seat slides rearwards when the seat belt tongue plate is disengaged from the front seat inner belt assembly LH (auto away function). Also the power seat slides forward when the seat belt tongue plate is engaged with the front seat inner belt assembly LH with the engine switch on (ACC) or on (IG), or the shift lever in P.

WIRING DIAGRAM

A01GHNCE01

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK FRONT POWER SEAT OPERATION


    1. Check that each function of the power seat operates normally by using the front power seat switch Click here.

      OK
      Each function of power seat operates normally by using seat switches.

    NG

    GO TO PROBLEM SYMPTOMS TABLE Click here

    OK

  2. READ VALUE USING INTELLIGENT TESTER (BUCKLE SWITCH)


    1. Check the Data List for proper functioning of the seat buckle switch.

      Driver Seat
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Driver Seat Buckle SW Driver seat seat belt usage / ON or OFF

      ON: Tongue plate is engaged

      OFF: Tongue plate is not engaged

      		 -
      OK
      On tester screen, each item changes between ON and OFF according to above chart.

    NG

    INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) Click here

    OK

  3. REPLACE FRONT POWER SEAT SWITCH (for Driver Side)


    1. Replace the front power seat switch Click here.


    NEXT

  4. CHECK POWER SEAT POWER EASY ACCESS SYSTEM


    1. Check that the power seat power easy access system operates normally when engaging and disengaging the tongue plate of the seat belt with the shift lever in P Click here.

      OK
      Power seat power easy access system is normal.

    NG

    REPLACE MAIN BODY ECU

    OK

    END (FRONT POWER SEAT SWITCH (for Driver Side) IS DEFECTIVE)

  5. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


    1. A01GJUWE01

      Remove the front seat inner belt assembly Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      1 (+) - 2 (E) Seat belt fastened Below 1 Ω
      1 (+) - 2 (E) Seat belt unfastened 10 kΩ or higher

    NG

    REPLACE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) Click here

    OK

  6. CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH - FRONT SEAT INNER BELT AND BODY GROUND)


    1. A01GNTTE01

      for LHD:


      1. Disconnect the e46 switch connector.

      2. Disconnect the e54 inner belt connector.

    2. for RHD:


      1. Disconnect the e79 switch connector.

      2. Disconnect the e57 inner belt connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      for LHD
      Tester Connection Condition Specified Condition
      e46-15 (DBCL) - e54-1 (+) Always Below 1 Ω
      e54-2 (E) - Body ground Always Below 1 Ω
      for RHD
      Tester Connection Condition Specified Condition
      e79-15 (DBCL) - e57-1 (+) Always Below 1 Ω
      e57-2 (E) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE FRONT POWER SEAT SWITCH (for Driver Side) Click here