INNER REAR VIEW MIRROR REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE MAP LIGHT ASSEMBLY

    A01GHRN

    1. Using a screwdriver, detach the 2 claws and 2 covers.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01GM9K

      Remove the 2 screws.

    3. A01GNOD

      Using a moulding remover, detach the 2 clips.

    4. Disconnect the connectors and remove the map light assembly.

  2. REMOVE RAIN SENSOR COVER (w/o Lane-keeping Assist System)

    A01GMO7E01

    1. Pull the stopper in the direction shown in the illustration.

    2. Detach the 2 claws and remove the rain sensor cover.

  3. REMOVE RAIN SENSOR COVER (w/ Lane-keeping Assist System)

    Note

    When removing and installing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".

    A01GKYHE02

    1. Pull the stopper in the direction shown in the illustration.

      A01GL7OE02

    2. While being careful not to apply force to the camera area, detach the 2 clips and 2 claws and remove the rain sensor cover.

  4. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System, Adaptive High Beam System)


    1. Disconnect the connector.

    2. A01GNSG

      Using a T20 "TORX" socket wrench, remove the screw and the inner rear view mirror.

  5. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/ Automatic High Beam System, Adaptive High Beam System)

    Note


    • Do not touch the camera lens (built into the inner rear view mirror assembly) with a bare hand.

    • Do not allow anything to adhere to the camera lens (built into the inner rear view mirror assembly).

    • Do not apply strong impacts to the inner rear view mirror assembly.

    • Do not allow any liquids to get on the inner rear view mirror assembly.


    1. Disconnect the connector.

    2. A01GMZ6

      Using a T20 "TORX" socket wrench, remove the screw and inner rear view mirror.