OUTER REAR VIEW MIRROR REMOVAL

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Remove the 6 clips and cowl top ventilator louver RH.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    1. A01GLM0E03
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 3 claws and remove the front door inside handle bezel plug LH.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    1. A01GLAV

      Using a moulding remover D, detach the 2 clips.

    2. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01GJPZ

      Remove the 3 screws.

    2. Detach the 13 clips and remove the front door trim board sub-assembly LH.

    3. Disconnect the connector.

    4. A01GL8K

      Disconnect the 2 cables from the inside handle.

  7. REMOVE DOOR FRAME GARNISH LH


    1. A01GMGE

      Remove the 2 clips and door frame garnish LH.

  8. REMOVE MULTIPLEX NETWORK FRONT DOOR ECU LH


    1. A01GNTU

      Remove the 2 screws and front multiplex network door ECU LH.

    2. Disconnect the 3 connectors.

  9. REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER LH


    1. A01GIHM

      Remove the front door No. 2 service hole cover LH.

      Tech Tips

      Remove the remaining tape on the door.

  10. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


    1. A01GIKP

      Detach the 3 clamps.

    2. Remove the 3 nuts and outer rear view mirror assembly LH.