POWER WINDOW REGULATOR MOTOR (for Rear Door) INSPECTION


  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH)


    1. A01GL6OE01

      Apply positive (+) battery voltage to the connector terminal 2.

      Note

      Do not apply positive (+) battery voltage to any terminals, except terminal 2, to avoid damaging the pulse sensor inside the motor.

    2. Apply negative (-) battery voltage to the connector terminals 1 and 7 / 10.

    3. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2

      Battery negative (-):

      1 (3 seconds or more) → 1 and 10 (within 1 second) → 1 (within 1 second) → 1 and 10

      		 Motor gear rotates counterclockwise (UP)

      Battery positive (+) → 2

      Battery negative (-):

      1 (3 seconds or more) → 1 and 7 (within 1 second) → 1 (within 1 second) → 1 and 7

      		 Motor gear rotates clockwise (DOWN)

      • If the result is not as specified, replace the regulator motor assembly.

      CAUTION:

      Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.

  2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH)


    1. A01GNCKE01

      Apply positive (+) battery voltage to the connector terminal 2.

      Note

      Do not apply positive (+) battery voltage to any terminals, except terminal 2, to avoid damaging the pulse sensor inside the motor.

    2. Apply negative (-) battery voltage to the connector terminals 1 and 7 / 10.

    3. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2

      Battery negative (-):

      1 (3 seconds or more) → 1 and 10 (within 1 second) → 1 (within 1 second) → 1 and 10

      		 Motor gear rotates clockwise (UP)

      Battery positive (+) → 2

      Battery negative (-):

      1 (3 seconds or more) → 1 and 7 (within 1 second) → 1 (within 1 second) → 1 and 7

      		 Motor gear rotates counterclockwise (DOWN)

      • If the result is not as specified, replace the regulator motor assembly.

      CAUTION:

      Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.