POWER WINDOW CONTROL SYSTEM Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH

DESCRIPTION



WIRING DIAGRAM

A01GL2GE03

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK FOR DTC


    1. Check for DTCs.

      Result:
      Result Proceed to
      B2311 is output A
      B2312 is output B
      B2313 is output C
      LIN communication system DTC is output D
      DTC is not output E

    A
    B
    C
    D
    E
  2. CHECK MANUAL UP / DOWN FUNCTION


    1. Check that the manual UP/DOWN function using the power window regulator switch can operate the driver door power window.

      OK
      Manual UP/DOWN function operates normally.

    NG
    OK
  3. READ VALUE USING INTELLIGENT TESTER (REAR MOTOR RH)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn ON the intelligent tester.

    4. Enter the following menus.


      1. Select: Body / RR-Door Motor / Data List

    5. According to the display on tester, read the "Data List".

      RR-Door Motor:
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      RR Door P/W Auto SW Rear power window RH remote auto UP/DOWN switch signal / ON or OFF

      ON: Rear power window RH remote auto UP/DOWN switch on master switch operated

      OFF: Rear power window RH switch on master switch not operated

      -
      OK
      Tester display changes normally when rear power window switch RH is operated.

    NG
    OK
  4. CHECK HARNESS AND CONNECTOR (REAR SWITCH RH - REAR MOTOR RH)


    1. A01GKL3E09

      Disconnect the N6 switch connector.

    2. Disconnect the N3 motor connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      O7-4 (AUTO) - O8-4 (AUTO) Always Below 1 Ω
      O7-4 (AUTO) or O8-4 (AUTO) - Body ground Always 10 kΩ or higher

    NG
    OK
  5. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear RH)

    A01GJPFE19

    1. Remove the switch.

    2. Measure the resistance of the switch when the switch is operated.

      Standard resistance
      Tester Connection Switch Condition Specified Condition
      O7-4 (AUTO) - O7-5 (GND) AUTO UP/DOWN operation Below 1 Ω

    NG
    OK