ULTRASONIC SENSOR (for Front Side) REMOVAL

Note

When replacing the sensor, only replace the clips and sensor.


  1. REMOVE FRONT BUMPER COVER

    Click here

  2. REMOVE NO. 4 ENGINE ROOM WIRE


    1. except Sport Package:


      1. Disconnect the 6 connectors.

      2. Detach the 7 clamps and remove the No. 4 engine room wire.

        A01GNAW

    2. for Sport Package:


      1. Disconnect the 6 connectors.

      2. Detach the 11 clamps and remove the No. 4 engine room wire.

        A01GN83
    3. A01GN77

      Detach the 2 claws and remove the clip.

      Tech Tips

      Use the same procedure to remove the clip on the other side.

  3. REMOVE NO. 1 ULTRASONIC SENSOR


    1. A01GLWR

      Remove the 6 No. 1 ultrasonic sensors as shown in the illustration.

      Note


      • Be careful not to damage the retainer.

      • Do not forcibly remove the retainer from the bumper cover.

  4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    1. A01GNT4

      While heating the retainer using a dryer, pull the retainer lightly and remove the double-sided tape. Then remove the 4 No. 1 ultrasonic sensor retainers.

      Heating temperature
      40 to 60°C (104 to 140°F)

      CAUTION:

      Be careful of burns.

    2. Using a cloth or non-residue solvent, wipe off any tape residue on the bumper cover.

  5. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER


    1. A01GNT4

      While heating the retainer using a dryer, pull the retainer lightly and remove the double-sided tape. Then remove the 2 No. 2 ultrasonic sensor retainers.

      Heating temperature
      40 to 60°C (104 to 140°F)

      CAUTION:

      Be careful of burns.

    2. Using a cloth or non-residue solvent, wipe off any tape residue on the bumper cover.