PARKING ASSIST MONITOR SYSTEM, Diagnostic DTC:C1625

DTC Code DTC Name
C1625 Open or Short in Steering Angle Sensor +B

DESCRIPTION

This DTC is stored if the multi-media module receiver assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem.

DTC Code DTC Detection Condition Trouble Area
C1625 Open or short in steering sensor +B

  • Harness or connector

  • Steering sensor

WIRING DIAGRAM

A01GJX9E01

INSPECTION PROCEDURE

Note


  • When "System initializing" is displayed on the accessory meter assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (STEERING SENSOR - BATTERY AND BODY GROUND)


    1. A01GMGKE09
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Steering Sensor)

      Disconnect the steering sensor connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L21-2 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      L21-1 (IG) - L21-2 (ESS) Engine switch on (IG) 11 to 14 V
      L21-3 (BAT) - L21-2 (ESS) Engine switch off 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE STEERING SENSOR Click here