TELEMATICS TRANSCEIVER REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    CAUTION:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    Note


    • When replacing the multi-media module receiver assembly or telematics transceiver, perform the vehicle contract setting Click here.

    • The safety connect device uses the telematics transceiver to provide access to the network service.

    • The telematics transceiver has a DCM ID (described on the label attached to the telematics transceiver.

  2. REMOVE COWL TOP VENTILATOR LOUVER RH

    A01GM4S

    1. Remove the 6 clips and cowl top ventilator louver RH.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. REMOVE INSTRUMENT SIDE PANEL RH

    A01GLH5E01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover D, detach the 6 clips and remove the instrument side panel RH.

  6. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01GKN8

    1. Detach the 4 claws and remove the No. 2 instrument panel under cover sub-assembly.

    2. Disconnect the connector.

  7. REMOVE LOWER INSTRUMENT PANEL


    1. A01GMJLE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the lower instrument panel.

    2. Using a screwdriver, detach the clip and 2 claws to remove the lower instrument panel.

  8. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01GLN3

      Remove the 3 bolts.

    4. Detach the claw to remove the front passenger side knee airbag assembly.

    5. Using a screwdriver release the airbag connector lock.

    6. Using a screwdriver, disconnect the airbag connector.

      Note

      When disconnecting airbag connector, take care not to damage the airbag wire harness.

  9. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01GKH6

    1. Remove the 5 screws <C> and glove compartment door assembly.

    2. Disconnect each connector and each wire harness clamp.

  10. REMOVE TELEMATICS TRANSCEIVER


    1. A01GN6K

      Remove the bolt and nut.

    2. Disconnect each connector and remove the telematics transceiver.

  11. REMOVE NO. 1 TELEPHONE BRACKET


    1. A01GJOY

      Remove the bolt and No. 1 telephone bracket.

  12. REMOVE NO. 2 TELEPHONE BRACKET


    1. A01GJR9

      Remove the bolt and No. 2 telephone bracket.