REMOTE TOUCH INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL REMOTE OPERATION SWITCH


    1. Install the remote operation switch with the 4 screws.

  2. INSTALL INTEGRATION PANEL SUB-ASSEMBLY


    1. A01GNAU

      Move the remote touch assembly in the direction of the arrow in the illustration.

    2. Install the 2 screws.

  3. INSTALL COVER


    1. Attach the 2 clips to install the cover.

  4. INSTALL SWITCH KNOB


    1. Push on the switch knob to install it.

      Tech Tips

      Make sure the orientation of the switch knob is correct when installing it.

  5. INSTALL REMOTE OPERATION BOARD


    1. A01GIWP

      Move the remote touch assembly in the direction of the arrow in the illustration and set it on the upper console panel sub-assembly.

    2. Attach the 7 claws to install the remote operation board.

  6. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY


    1. Connect each connector and attach each wire harness clamp.

    2. A01GNRT

      Attach the 6 clips to install the upper rear console panel sub-assembly.

    3. Install the 2 screws.

  7. INSTALL NO. 3 BOX PANEL


    1. Attach the 4 claws to install the No. 3 box panel.

  8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A01GITL

      Twist the shift lever knob sub-assembly in the direction indicated by the arrow to install it.

    2. A01GJKF

      Pull up the shift lever boot to connect it to the shift lever knob sub-assembly.

  9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


    1. Attach the rear part of the instrument panel finish panel end LH 3 clips.

    2. Attach the front part of the instrument panel finish panel end LH 6 clips to install the instrument panel finish panel end LH.

  10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Tech Tips

    Use the same procedure described for the LH side.