NAVIGATION ANTENNA INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL NAVIGATION ANTENNA ASSEMBLY


    1. Attach the 4 clamps.

    2. Install the navigation antenna assembly with the 2 screws.

  2. INSTALL NO. 3 HEATER TO REGISTER DUCT


    1. Install the No. 3 heater to register duct with the 3 screws.

  3. INSTALL DEFROSTER NOZZLE ASSEMBLY


    1. Install the defroster nozzle assembly with the 3 screws.

  4. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT


    1. Attach the claw to install the No. 2 side defroster nozzle duct.

    2. Install the screw.

  5. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

  8. CHECK SRS WARNING LIGHT

    Click here