STEREO JACK ADAPTER ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    A01GLHB

    1. Pull the front part of the instrument panel finish panel end LH to detach the 6 clips.

    2. Pull the instrument panel finish panel end LH to detach 3 clips and remove the instrument panel finish panel end LH.

  2. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A01GJB3

      Lower the shift lever boot and disconnect it from the shift lever knob sub-assembly.

    2. A01GKLB

      Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.

  4. REMOVE NO. 3 BOX PANEL

    A01GJKI

    1. Detach the 4 claws and remove the No. 3 box panel.

  5. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

    A01GKM5E01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Move the shift lever to N.

    3. Remove the 2 screws.

    4. Detach the 6 clips and remove the upper rear console panel sub-assembly.

    5. Disconnect each connector and each wire harness clamp.

  6. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY


    1. A01GKS4

      Disconnect the 2 connectors.

    2. Detach the 2 claws and remove the No. 1 stereo jack adapter assembly.

  7. REMOVE REAR CENTER SEAT CUSHION ASSEMBLY (for Power Seat, for 5-Passenger with Ottoman)


    1. A01GJWX

      Detach the front hook of the rear center seat cushion assembly from the vehicle body.

      Note

      The cushion frame deforms easily. To avoid deforming the rear center seat cushion assembly, place your hands near the hook, and then pull up on the rear center seat cushion assembly.

    2. Detach the rear hook of the rear center seat cushion assembly to remove the rear center seat cushion assembly from the center seatback frame sub-assembly.

      Note

      Be careful not to damage the vehicle body.

  8. REMOVE REAR SEAT CENTER ARMREST ASSEMBLY (for Power Seat, for 5-Passenger with Ottoman)


    1. Lower the rear seat center armrest assembly.

    2. A01GNG6

      Raise the rear center seat headrest assembly.

    3. A01GO13E04

      Detach the 2 clips.

    4. Detach the hook by lowering the rear seat armrest hole board, and remove it.

    5. A01GJRU

      Remove the 2 bolts, nut and rear seat center armrest assembly.

      Note

      Be careful not to damage the vehicle body.

    6. Disconnect the 2 connectors.

  9. REMOVE HEADPHONE TERMINAL (for Power Seat, for 5-Passenger with Ottoman)


    1. Disconnect each connector.

    2. A01GLJJ

      Using a moulding remover B, detach the 8 claws and remove the bezel.

    3. A01GKMJ

      Detach the 6 claws and remove the 2 headphone terminals.

  10. REMOVE REAR SEAT LOWER CONSOLE BOX COVER (for 4-Passenger with Ottoman)


    1. A01GJX7E03

      Using a screwdriver, detach the 4 claws, then detach the 2 hooks and remove the rear seat lower console box cover.

      Tech Tips

      Tape the screwdriver tip before use.

  11. REMOVE REAR SEAT CONSOLE BOX ASSEMBLY (for 4-Passenger with Ottoman)


    1. A01GLZ1

      Using a screwdriver, detach the 4 clips and remove the rear seat console box front panel.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01GK02

      Remove the 6 bolts, and move the rear seat console box assembly in the direction of the arrow shown in the illustration. Then detach the 2 clips, and remove it.

    3. A01GKJU

      Disconnect the connector.

  12. REMOVE REAR SEAT CONSOLE BOX PANEL (for 4-Passenger with Ottoman)


    1. A01GN2O

      Detach the 4 clips and remove the rear seat console box panel.

  13. REMOVE HEADPHONE TERMINAL (for 4-Passenger with Ottoman)


    1. A01GLOW

      Disconnect the 2 connectors.

    2. Detach the 2 clamps.

    3. Detach the 6 claws and remove the 2 headphone terminals.