INSTRUMENT PANEL SPEAKER REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE NO. 1 SPEAKER HOLE COVER


    1. A01GNJN

      Detach the 4 clips, claw and clamp and remove the No. 1 speaker hole cover.

  2. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY


    1. Remove the 2 bolts.

      A01GJTRE01
      Text in Illustration
      *A for Standard *B for 19 Speaker

    2. Disconnect the connector and remove the front No. 3 speaker assembly.

      Note

      Do not touch the cone of the speaker.

  3. REMOVE FRONT PILLAR GARNISH LH

    A01GLU3E01
    Text in Illustration
    *1 Front Pillar Garnish Clip

    1. Pull the upper part of the front pillar garnish LH toward the inside of the cabin and detach the 2 clips.

      Tech Tips

      Make the front pillar garnish LH hang down from the front pillar garnish clip.

    2. A01GIDYE01
      Text in Illustration
      *1 Front Pillar Garnish Clip
      *2 Protective Tape

      Turn the end of the front pillar garnish clip 90° with needle-nose pliers and remove it from the front pillar garnish LH.

      Note


      • Front pillar garnish clips are reusable if they are not removed from the vehicle and have no damage.

      • Replace the front pillar garnish clips with new ones if they are removed from the vehicle.

      Tech Tips

      Tape the tips of the needle-nose pliers before use.

    3. Pull the front pillar garnish LH to detach the guide and remove it.

    4. A01GJHJE06
      Text in Illustration
      *1 Adhesive Tape
      *2 Protective Cover

      Protect the curtain shield airbag assembly LH.

      Completely cover the curtain shield airbag assembly LH with a cloth or nylon sheet and secure the ends of the cover with adhesive tape as shown in the illustration.

      Note

      Cover the curtain shield airbag assembly LH with a protective cover as soon as the front pillar garnish LH is removed.

  4. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

    A01GKHR

    1. Detach the 2 clips and 7 claws.

    2. Remove the No. 1 instrument panel speaker panel sub-assembly.

  5. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    1. Remove the 2 bolts.

      A01GJ2CE02
      Text in Illustration
      *A for Standard *B for 19 Speaker

    2. Disconnect the connector and remove the front No. 2 speaker assembly.

      Note

      Do not touch the cone of the speaker.