AUDIO AND VISUAL SYSTEM Display Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the multi-media module receiver assembly via this circuit.

WIRING DIAGRAM

A01GKSGE10

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the L147 multi-media module receiver assembly connector.

    2. Disconnect the L182 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L147-6 (VV+) - L182-8 (VV+) Always Below 1 Ω
      L147-14 (VV-) - L182-9 (VV-) Always Below 1 Ω
      L147-6 (VV+) or L182-8 (VV+) - Body ground Always 10 kΩ or higher
      L147-14 (VV-) or L182-9 (VV-) - Body ground Always 10 kΩ or higher
      L147-13 (SG) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here