RAIN SENSOR INSTALLATION


  1. INSTALL RAIN SENSOR TAPE


    1. A01GK3WE01

      If reusing the rain sensor:

      Install new rain sensor tape.


      1. Remove the used rain sensor tape from the windshield glass or rain sensor.

      2. Apply new rain sensor tape on the rain sensor lens surface indicated by the hatched area.

        Note


        • Keep the tape's exposed adhesive free from dust and fingerprints.

        • Apply the tape exactly according to the specifications below.

          Specification
          Area Measurement
          A 15.0 mm (0.591 in.)
          B 8.0 mm (0.315 in.)

  2. INSTALL RAIN SENSOR

    Note


    • Make sure the adhesive between the bracket and windshield glass is normal.

    • If there is any residue left from the rain sensor tape on the windshield, remove it.

    • Clean the glass surface with a cloth or similar material.

    • Make sure there are no air bubbles between the rain sensor and windshield.


    1. Peel the peeling paper from the rain sensor tape.

    2. Securely attach the rain sensor to the bracket.

    3. Push the stopper upward.

    4. Connect the connector.

      A01GN8HE01

  3. INSTALL INNER REAR VIEW MIRROR ASSEMBLY


    1. w/o Automatic High Beam System, Adaptive High Beam System:

      Install the inner rear view mirror assembly Click here.

    2. w/ Automatic High Beam System, Adaptive High Beam System:

      Install the inner rear view mirror assembly Click here.

  4. INSTALL RAIN SENSOR COVER (w/ Lane Keeping Assist System)

    Note

    When removing and installing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".

    A01GKYHE01
    Text in Illustration
    *1 Clip
    *2 Camera

    1. A01GN60E01

      While being careful not to apply force to the camera area, attach the 2 claws and 2 clips to install the rain sensor cover.

    2. Push the stopper as shown in the illustration to fix the cover in place.

      Text in Illustration
      *1 Stopper

  5. INSTALL RAIN SENSOR COVER (w/o Lane Keeping Assist System)


    1. A01GIV5E01

      Attach the 2 claws to install the rain sensor cover.

    2. Push the stopper as shown in the illustration to fix the cover in place.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      Be sure to install the cowl top ventilator louver RH properly. If it is not installed properly, water may enter the engine room and cause malfunctions.

  8. ADJUST ADAPTIVE HIGH BEAM CAMERA BEAM AXIS (w/ Adaptive High Beam System)

    Click here