ROOM LIGHT ASSEMBLY (for Rear) INSPECTION


  1. INSPECT SPOT LIGHT ASSEMBLY

    A01GN1VE01
    Text in Illustration
    *a

    Component without harness connected

    (Spot Light Assembly)

    1. Apply battery voltage to the connector and check the light illumination condition.

      OK
      Connection Specified Condition

      Battery positive (+) → Terminal 14 (RRMP)

      Battery negative (-) → Terminal 5 (RGND)

      		 Rear spot light RH illuminates

      Battery positive (+) → Terminal 4 (RLMP)

      Battery negative (-) → Terminal 5 (RGND)

      		 Rear spot light LH illuminates

      If the result is not as specified, replace the spot light assembly.

    2. A01GN1VE02
      Text in Illustration
      *a

      Component without harness connected

      (Spot Light Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      7 (RRSW) - 5 (RGND) Switch on both sides OFF 10 kΩ or higher
      6 (RLSW) - 5 (RGND) Switch on both sides OFF 10 kΩ or higher
      7 (RRSW) - 5 (RGND) Rear right side switch ON Below 1 Ω
      6 (RLSW) - 5 (RGND) Rear left side switch ON Below 1 Ω

      If the result is not as specified, replace the spot light assembly.