DRIVER MONITOR CAMERA INSTALLATION

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. INSTALL DRIVER MONITOR CAMERA


    1. Attach the 2 claws and install the driver monitor camera with the 2 screws.

      Torque:
      1.8 N*m  { 18 kgf*cm, 16 in.*lbf }

  2. INSTALL DRIVER MONITOR BRACKET


    1. Attach the guide and install the driver monitor bracket with the screw.

      Torque:
      1.8 N*m  { 18 kgf*cm, 16 in.*lbf }
    2. A01GMBX

      Attach the claw to connect the driver monitor camera connector.

      Note

      Make sure that the wire harness of the driver monitor camera is positioned as shown in the illustration.

  3. INSTALL STEERING COLUMN COVER


    1. for Upper Side:


      1. Attach the claw to install the steering column cover.

      2. Connect the driver monitor camera connector.

      3. Attach the 4 clips to install the instrument cluster finish panel sub-assembly.

    2. for Lower Side:


      1. Attach the 2 claws to install the steering column cover.

      2. Install the 3 screws.

  4. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY


    1. Connect each connector.

    2. Attach the 5 clips and claw to install the No. 1 instrument panel safety pad sub-assembly.

    3. Install the screw <C> and bolt.

    4. A01GK0Y

      Attach the claw to install the switch base hole cover to the No. 1 instrument panel safety pad sub-assembly.

  5. INSTALL INSTRUMENT PANEL ORNAMENT

    A01GKTP

    1. Connect the connector.

    2. Attach the 4 clips to install the instrument panel ornament.

  6. INSTALL INSTRUMENT SIDE PANEL LH

    A01GIB5

    1. Attach the 6 clips to install the instrument side panel LH.

  7. ENABLE AUTO TILT AWAY FUNCTION

    Note

    Restore the Autoaway/Return function setting to the previous condition by changing the customize parameter Click here.