DRIVER MONITOR CAMERA REMOVAL

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the Autoaway/Return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.

    3. Turn the engine switch off.

  2. REMOVE INSTRUMENT SIDE PANEL LH

    A01GIOAE01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover D, detach the 6 clips and remove the instrument side panel LH.

  3. REMOVE INSTRUMENT PANEL ORNAMENT

    A01GN0QE01
    Text in Illustration
    *1 Protective Tape

    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover B, detach the 4 clips and remove the instrument panel ornament.

    3. Disconnect the connector.

  4. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    A01GMOEE01

    1. Using a screwdriver, detach the claw and remove the switch base hole cover from the No. 1 instrument panel safety pad sub-assembly.

      Tech Tips

      Tape the screwdriver tip before use.

      Text in Illustration
      *1 Protective Tape
    2. A01GNWZ

      Remove the bolt.

    3. Remove the screw <C>.

    4. Detach the 5 clips and claw and remove the No. 1 instrument panel safety pad sub-assembly.

    5. Disconnect each connector.

  5. REMOVE STEERING COLUMN COVER


    1. for Lower Side:


      1. Remove the 3 screws.

        A01GJMV
      2. A01GNVP

        Detach the 2 claws to remove the steering column cover.

    2. for Upper Side:


      1. A01GILN

        Detach the 4 clips to remove the instrument cluster finish panel sub-assembly.

      2. A01GHVI

        Disconnect the driver monitor camera connector.

      3. A01GLO0

        Detach the claw to remove the steering column cover.

  6. REMOVE DRIVER MONITOR BRACKET


    1. A01GKMB

      Detach the claw and disconnect the driver monitor camera connector.

    2. Remove the screw.

    3. Detach the guide and remove the driver monitor bracket.

  7. REMOVE DRIVER MONITOR CAMERA


    1. A01GJTZ

      Remove the 2 screws.

    2. Detach the 2 claws and remove the driver monitor camera.