AIR CONDITIONING AMPLIFIER INSTALLATION

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY


    1. A01GK6RE01
      Text in Illustration
      *1 Protrusion Part
      *2 Fitting Point

      Insert the protrusion part of the air conditioning amplifier assembly to the fitting point of the air conditioning unit, and then align the hole of the air conditioning unit assembly with the locating pin of the air conditioning unit and install the screw.

    2. Connect the 3 connectors.

  2. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY


    1. Attach the 2 claws to install the No. 2 air duct sub-assembly.

    2. Install the screw.

  3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    1. Connect each connector and each wire harness clamp.

    2. Install the glove compartment door assembly with the 5 screws <C>.

  4. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Push in the lock to connect the airbag connector.

    4. A01GLBI

      Connect the airbag connector to the front passenger side knee airbag assembly.

      Note

      When connecting airbag connector, take care not to damage the airbag wire harness.

    5. Attach the claw to install the front passenger side knee airbag assembly.

    6. Install the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the front passenger side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  5. INSTALL LOWER INSTRUMENT PANEL


    1. Attach the 2 claws and clip to install the lower instrument panel.

  6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connector.

    2. A01GLCW

      Insert the 2 guides.

    3. Attach the 4 claws to install the No. 2 instrument panel under cover sub-assembly.

  7. INSTALL INSTRUMENT SIDE PANEL RH

    A01GNEH

    1. Attach the 6 clips to install the instrument side panel RH.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      for LHD:

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

    2. A01GI9P

      for RHD:

      Install the 6 clips and cowl top ventilator louver LH.

      Note

      If the cowl top ventilator louver LH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver LH is installed properly.

  10. CHECK SRS WARNING LIGHT

    Click here