DESCRIPTION
This circuit consists of the infrared ray sensor and the air conditioning amplifier. The infrared ray sensor, which is installed on the rear roof, detects human body temperature and control the heater and air conditioner "AUTO" mode in 4 zones. Signals are transmitted to the air conditioning amplifier via the LIN communication line. This DTC is output when communication between the infrared ray sensor and the air conditioning amplifier stops for 10 seconds or more. If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the infrared ray sensor is normal.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1492/92 | Open in LIN communication line |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
CHECK HARNESS AND CONNECTOR (INFRARED RAY SENSOR - AIR CONDITIONING AMPLIFIER)
Disconnect the X13 infrared ray sensor connector.
Disconnect the L76 air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Standard resistance | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
REPLACE INFRARED RAY SENSOR
Replace the infrared ray sensor with a new or properly functioning one Click here.
Operate the infrared ray sensor to check that it functions properly.
| Result | Proceed to |
|---|---|
| Infrared ray sensor malfunctions | A |
| Infrared ray sensor functions properly | B |
| B |
|
END (INFRARED RAY SENSOR IS FAULTY) |
| A |
|
REPLACE AIR CONDITIONING AMPLIFIER Click here