DC / DC CONVERTER INSTALLATION


  1. INSTALL POWER STEERING CONVERTER ASSEMBLY


    1. A01GJQB

      Install the converter with the 3 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
    2. A01GKZUE01

      Connect the 2 converter connectors A and B, and securely lock the connectors.

  2. INSTALL BATTERY TRAY


    1. Install the battery tray with the 3 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 47 in.*lbf }

  3. INSTALL BATTERY


    1. Install the battery.

    2. Install the battery insulator.

    3. Install the battery clamp with the 2 nuts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 47 in.*lbf }

    4. Connect the positive (+) battery cable to the battery terminal.

      Torque:
      5.6 N*m  { 57 kgf*cm, 50 in.*lbf }

    5. Connect the negative (-) battery cable to the battery terminal.

      Torque:
      5.6 N*m  { 57 kgf*cm, 50 in.*lbf }

  4. INSTALL COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

    2. A01GI9P

      for RHD:

      Install the 6 clips and cowl top ventilator louver LH.

      Note

      If the cowl top ventilator louver LH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver LH is installed properly.

  5. CHECK SRS WARNING LIGHT

    Click here

  6. PERFORM INITIALIZATION

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.