POWER STEERING ECU INSTALLATION


  1. INSTALL POWER STEERING ECU


    1. A01GIR5

      Attach the claw and install the power steering ECU with the 4 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    2. Connect connector C to the power steering ECU.

      A01GMIBE01

    3. Connect the 2 power steering ECU connectors A and B and securely lock the connectors.

  2. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY


    1. A01GLYAE01

      Attach the 4 clips labeled B.

      Note


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.

    2. Install the air cleaner inlet cover sub-assembly with the 5 clips labeled A.

  3. INSTALL ENGINE ROOM SIDE COVER


    1. Install the engine room side cover RH with the 5 clips.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  5. INSTALL COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

    2. A01GI9P

      for RHD:

      Install the 6 clips and cowl top ventilator louver LH.

      Note

      If the cowl top ventilator louver LH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver LH is installed properly.

  6. PERFORM INITIALIZATION

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION

    Click here