HEATED STEERING WHEEL CONTROLLER INSTALLATION


  1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY


    1. Install the heater control assembly with the 2 screws and connect the connector clamp.

  2. INSTALL STEERING WHEEL BOSS COVER LOWER


    1. w/o Shift Paddle Switch:

      Attach the 2 guide pins, 2 claws and 2 screws to install the steering wheel lower cover.

    2. w/ Shift Paddle Switch:

      Attach the 2 claws and a new 4 screws to install the steering wheel lower cover.

  3. INSTALL CRUISE CONTROL MAIN SWITCH ASSEMBLY


    1. A01GML0

      Connect the connector and install the cruise control main switch assembly.

    2. Install the 2 screws.

  4. INSTALL STEERING PAD SWITCH ASSEMBLY


    1. Install the steering pad switch with the 4 screws and connect the 6 guide pins.

    2. Connect the connector clamp.

  5. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  7. INSTALL COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

    2. A01GI9P

      for RHD:

      Install the 6 clips and cowl top ventilator louver LH.

      Note

      If the cowl top ventilator louver LH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver LH is installed properly.

  8. CHECK SRS WARNING LIGHT

    Click here

  9. PERFORM INITIALIZATION

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.