TILT AND TELESCOPIC MANUAL SWITCH INSTALLATION

Tech Tips


  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are for the LHD.


  1. INSTALL TILT AND TELESCOPIC MANUAL SWITCH


    1. Attach the claw to install the switch.

    2. Connect the switch connector.

  2. INSTALL STEERING COLUMN COVER


    1. Attach the 2 claws to install the steering column cover.

    2. Install the 3 screws.

      Tech Tips

      Turn the steering wheel to the right and left as necessary to install the 2 screws.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Click here.

  4. INSTALL COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

    2. A01GI9P

      for RHD:

      Install the 6 clips and cowl top ventilator louver LH.

      Note

      If the cowl top ventilator louver LH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver LH is installed properly.

  5. PERFORM INITIALIZATION

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.