STEERING COLUMN ASSEMBLY (for 2WD with VGRS) INSPECTION


  1. INSPECT TILT MOTOR


    1. A01GLVKE14
      Text in Illustration
      *a Component without harness connected: (Tilt Motor Connector)
      *b Component without harness connected: (Tilt Motor Connector)

      Disconnect connector from the multiplex tilt and telescopic ECU.

    2. Inspect the tilt motor.


      1. Connect the positive battery terminal to terminal TIM+ and the negative battery terminal to terminal TIM- of the tilt motor connector. Then confirm that the steering wheel tilts up.

        OK
        Steering wheel tilts up.

      2. Connect the negative battery terminal to terminal TIM+ and the positive battery terminal to terminal TIM- of the tilt motor connector. Then confirm that the steering wheel tilts down.

        OK
        Steering wheel tilts down.

  2. INSPECT TELESCOPIC MOTOR


    1. A01GIVYE11
      Text in Illustration
      *a Rear view of wire harness connector: (to Multiplex Tilt and Telescopic ECU)

      Disconnect connector A from the multiplex tilt and telescopic ECU.

    2. Inspect the telescopic motor.


      1. Connect the positive battery terminal to terminal TEM+ and the negative battery terminal to terminal TEM- of the telescopic motor connector. Then confirm that the steering column contracts.

        OK
        Steering column contracts.

      2. Connect the negative battery terminal to terminal TEM+ and the positive battery terminal to terminal TEM- of the telescopic motor connector. Then confirm that the steering column extends.

        OK
        Steering column extends.