PARKING BRAKE ASSEMBLY DISASSEMBLY

Tech Tips


  • Use the same procedures for the LH side and RH side.


  • The procedures listed below are for LH the side.

CAUTION:

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed with the door courtesy switch on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.


  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY


    1. A01GKRW

      Remove the 2 bolts and disconnect the rear disc brake caliper.

      Note

      Hang the caliper with wire or equivalent.

  3. REMOVE REAR DISC


    1. A01GLUOE02
      Text in Illustration
      *a Matchmark
      *b Contract

      Put matchmarks on the rear disc and rear axle hub.

    2. Remove the rear disc.

      Tech Tips

      If the rear disc is difficult to remove, turn the adjustment screw in the contraction direction as shown in the illustration to make the disc easier to remove.

  4. REMOVE NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING


    1. A01GM9QE01

      Using SST, remove the shoe return spring.

      SST
      09703-30011

  5. REMOVE NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING


    1. A01GJ28E01

      Using SST, remove the shoe return spring.

      SST
      09703-30011

  6. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET


    1. A01GLFY

      Slide the parking brake shoe, and remove the parking brake shoe adjusting screw set.

  7. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY


    1. A01GJ7HE01

      Using SST, remove the No. 2 shoe hold down spring cup, No. 2 compression spring and No. 1 shoe hold down spring pin.

      SST
      09718-00010

      Tech Tips

      Use the service hole to retain the No. 1 shoe hold down spring pin with your finger.

    2. Remove the No. 2 parking brake shoe.

  8. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY


    1. A01GNRQE01

      Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.

      SST
      09718-00010

      Tech Tips

      Use the service hole to retain the No. 1 shoe hold down spring pin with your finger.

    2. Remove the No. 1 parking brake shoe.

  9. REMOVE PARKING BRAKE SHOE LEVER


    1. A01GLXU

      Remove the parking brake shoe lever.

  10. DISCONNECT PARKING BRAKE CABLE


    1. A01GJVQ

      Remove the 2 nuts and disconnect the parking brake cable.

  11. REMOVE PARKING BRAKE ANCHOR BLOCK SUB-ASSEMBLY


    1. Remove the rear axle hub and bearing assembly Click here.

    2. A01GI3A

      Remove the 2 nuts, cable support bracket and parking brake anchor block.