SKID CONTROL BUZZER INSTALLATION

Tech Tips


  • Use the same procedure for the RHD and LHD vehicles.

  • The procedure listed is for the LHD vehicles.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.


  1. INSTALL SKID CONTROL BUZZER ASSEMBLY

    Note

    If the buzzer connector is connected with the buzzer installed to the vehicle, the clamp of the buzzer may be damaged. Make sure to install the buzzer according to the procedures below.


    1. Connect the connector.

    2. A01GID8

      Attach the clamp and install the buzzer to the extension panel.

  2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after cable is reconnected Click here.

  4. INSTALL COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      Be sure to install the cowl top ventilator louver RH properly. If it is not installed properly, water may enter the engine room and cause malfunctions.