SKID CONTROL ECU (for LHD) INSTALLATION

Tech Tips


  • The following procedures are for LHD vehicles.

  • For RHD vehicles, refer to the procedures for RHD vehicles Click here.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.


  1. INSTALL SKID CONTROL ECU BRACKET


    1. A01GIZTE02
      Text in Illustration
      *a Front

      Install the bracket with the bolt and 2 nuts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

  2. INSTALL SKID CONTROL ECU


    1. A01GJNHE01

      Connect the 2 connectors (labeled A) and press the lock levers down to lock the connectors.

      Note

      Make sure that the lock levers securely lock the connectors.

    2. Connect the connector (labeled B).

    3. A01GJ56E07
      Text in Illustration
      *a Front

      Install the ECU with the 2 bolts (labeled C) and nut (labeled D).

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    4. Connect the short connector for the brake stroke simulator (labeled E) to the bracket of the skid control ECU.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL COWL TOP VENTILATOR LOUVER RH


    1. A01GM4S

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      Be sure to install the cowl top ventilator louver RH properly. If it is not installed properly, water may enter the engine room and cause malfunctions.

  5. CHECK AND CLEAR DTC

    Click here

  6. PERFORM LINEAR VALVE OFFSET LEARNING

    Click here

  7. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

    Click here

  8. PERFORM TEST MODE INSPECTION

    Click here

  9. INSTALL ENGINE ROOM SIDE COVER LH


    1. Install the engine room side cover LH with the 5 clips.

  10. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01GMKRE01

      Slide the cover from the vehicle front toward the rear of the vehicle to attach the 2 clips labeled A, and then attach the 4 clips labeled B to install the V bank cover sub-assembly.

      Note


      • Make sure the clips are attached securely.

      • Attaching the clips forcefully or hitting the top of the clips may damage them.

      • When attaching the clips labeled A, be sure to slide the cover from the front of the vehicle toward the rear of the vehicle.