FRONT SPEED SENSOR (for AWD) REMOVAL

Tech Tips


  • The procedures listed below are for the RH side.

  • Use the same procedure for the RH and LH sides.

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.


  1. REMOVE COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Remove the 6 clips and cowl top ventilator louver RH.

    2. A01GI9P

      for RHD:

      Remove the 6 clips and cowl top ventilator louver LH.

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT WHEEL

  5. REMOVE SKID CONTROL SENSOR WIRE


    1. A01GKWLE03
      Text in Illustration
      *1 Fender Liner

      Disconnect the front fender liner so that the skid control sensor wire connector can be disconnected.

    2. Disconnect the sensor connector.

    3. Detach the 2 sensor clips.

    4. A01GI8WE01

      Remove the 2 bolts and 2 sensor clamps.

    5. A01GL7RE01

      Disconnect the pad wear indicator connector.

    6. Disconnect the connector from the front speed sensor.

    7. Remove the bolt and sensor clamp.

  6. REMOVE FRONT SPEED SENSOR RH


    1. A01GKDS

      Remove the bolt and sensor.

      Note


      • The speed sensor is easily damaged.

        When pulling out the speed sensor from the axle hub, do not use excessive force to rotate and remove it.

      • Prevent foreign matter from attaching to the sensor tip.

      • Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.