REAR STABILIZER BAR INSPECTION


  1. INSPECT REAR STABILIZER LINK ASSEMBLY LH

    A01GMKD

    1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

    2. Use a torque wrench to turn the nut continuously at a rate of 3 to 5 seconds per turn. Take the torque reading on the fifth turn.

      Standard turning torque
      1.96 N*m (20 kgf*cm, 17 in.*lbf)

      • If the value is not within the specified range, replace the rear suspension toe control link with a new one

    3. Check the dust boot for cracks or grease leakage.