SUSPENSION CONTROL ECU (for RHD) INSTALLATION

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL SUSPENSION CONTROL ECU


    1. A01GM1I

      Install the suspension control ECU to the bracket with the 2 nuts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note


      • Avoid any impact to the suspension control ECU.

      • Do not drop the ECU. If it is dropped, replace it with a new one.

  2. INSTALL NETWORK GATEWAY ECU (w/ Network Gateway ECU)


    1. Install the network gateway ECU with the 2 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    2. Install the No. 1 ECU integration bracket with the 2 nuts.

    3. Connect each connector.

  3. INSTALL SUSPENSION CONTROL ECU WITH BRACKET (w/o Network Gateway ECU)


    1. A01GJFV

      Install the ECU with bracket with the 2 nuts.

    2. A01GN6X

      Connect the connectors.

      Note

      If the suspension control ECU is replaced with a new one, enter test mode and perform registration of vehicle identification information Click here.

  4. CONNECT CONNECTORS (w/ Driver Monitor ECU)

  5. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  6. ADJUST VEHICLE HEIGHT

    Note

    If the suspension control ECU has been replaced, be sure to adjust the vehicle height Click here.