HEIGHT CONTROL SENSOR (for Rear LH) INSTALLATION

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. INSTALL LOAD SENSING VALVE SENSOR BRACKET


    1. Install the bracket to the lower arm with the bolt.

  2. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR LH


    1. A01GI1Z

      Install the height control sensor with the 2 bolts.

      Torque:
      13.5 N*m  { 138 kgf*cm, 10 ft.*lbf }

      Note

      Do not drop the height control sensor. If it is dropped, replace it with a new one.

    2. A01GMVU

      Align the matchmarks on the height control sensor link and bracket.

    3. Install the nut to the height control sensor link.

      Torque:
      5.3 N*m  { 54 kgf*cm, 47 in.*lbf }

    4. Connect the connector.

  3. CHECK VEHICLE HEIGHT

    Note

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.

    2. Measure the vehicle height Click here.

  4. ADJUST VEHICLE HEIGHT

    Click here

    Note

    If the height control sensor has been replaced, be sure to adjust the vehicle height.