READ DATA LIST
Tech Tips
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the engine switch off.
Connect the intelligent tester the DLC3.
Turn the engine switch on (IG) and the tester ON.
Enter the following menus:
Select: Chassis / Air suspension / Data List /
Read the Data List by following the directions on the tester screen.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| (Up & Down)G Sensor FR | G (up & down) suspension control ECU (houses acceleration sensor) reading / min.: -1045.29 m/s2 max.: 1045.26 m/s2 |
0 +/-0.98 m/s2at still condition |
Reading changes when vehicle (FR) is bounced |
| (Up & Down)G Sensor FL | G (up & down) acceleration sensor (for Front) reading / min.: -1045.29 m/s2 max.: 1045.26 m/s2 |
0 +/-0.98 m/s2at still condition |
Reading changes when vehicle (FL) is bounced |
| (Up & Down)G Sensor Rear | G (up & down) acceleration sensor (for Rear) reading / min.: -1045.29 m/s2 max.: 1045.26 m/s2 |
0 +/-0.98 m/s2at still condition |
Reading changes when vehicle (rear) is bounced |
| (Back & Forth)G Sensor | G sensor reading / min.: -4.5952 m/s2 max.: 4.5593 m/s2 |
0 +/-0.98 m/s2at still condition |
Reading changes when vehicle is bounced |
| FR Height Control Sensor | Front height control sensor RH reading / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| FL Height Control Sensor | Front height control sensor LH reading / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| RR Height Control Sensor | Rear height control sensor RH reading / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| RL Height Control Sensor | Rear height control sensor LH reading / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| Height Offset Max | Display of amount of vehicle height calibration that is possible / min.: 0 mm (0 in.) max.: 6553.5 mm (258 in.) |
min.: 0 mm (0 in.) max.: 20 mm (0.787 in.) |
- |
| FR Height Adjust | Display of vehicle height offset recorded value of front right wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| FL Height Adjust | Display of vehicle height offset recorded value of front left wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| RR Height Adjust | Display of vehicle height offset recorded value of rear right wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| RL Height Adjust | Display of vehicle height offset recorded value of rear left wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
- | - |
| FR After Height Adjust | Display of after-calibration vehicle height value of front right wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
except Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/- 0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/- 20 mm (0.787 +/- 0.787 in.) |
- |
| for Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/- 0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 30 +/- 20 mm (1.181 +/- 0.787 in.) |
|||
| FL After Height Adjust | Display of after-calibration vehicle height value of front left wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
except Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/- 0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/- 20 mm (0.787 +/- 0.787 in.) |
- |
| for Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/- 0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 30 +/- 20 mm (1.181 +/- 0.787 in.) |
|||
| RR After Height Adjust | Display of after-calibration vehicle height value of rear right wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
except Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/- 0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/- 20 mm (0.787 +/- 0.787 in.) |
- |
| for Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/- 0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 30 +/- 20 mm (1.181 +/- 0.787 in.) |
|||
| RL After Height Adjust | Display of after-calibration vehicle height value of rear left wheel / min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.) |
except Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/- 0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/- 20 mm (0.787 +/- 0.787 in.) |
- |
| for Sports Package: When vehicle height normal: 0 +/-20 mm (0 +/- 0.787 in.) When vehicle height changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 30 +/- 20 mm (1.181 +/- 0.787 in.) |
|||
| Stop Light Switch | Stop light switch / ON or OFF |
ON: Brake pedal depressed OFF: Brake pedal released |
- |
| COMFORT Switch | Drive mode select switch "COMFORT" mode / ON or OFF |
ON: COMF mode OFF: Not in COMF mode |
- |
| SPORT Switch | Drive mode select switch "SPORT S+" mode / ON or OFF |
ON: SPORT S+ mode OFF: Not in SPORT S+ mode |
- |
| Door Switch | Door switch / ON or OFF |
ON: Open a door OFF: Close all doors |
- |
| Damping Force Switch 1 | Height control switch / ON or OFF |
ON: Switch is pressed and held OFF: Switch is not pressed |
- |
| Height Position | Vehicle height position / Normal or Not Normal |
Normal: Vehicle height position is normal Not Normal: Vehicle height position is not normal |
- |
| Height Control | Vehicle height control condition reading / ON or OFF |
ON: Vehicle height control operating OFF: Vehicle height control not operating |
- |
| Height Offset | Vehicle height offset calibration condition reading / ON or OFF |
ON: Vehicle height offset calibration complete OFF: Before vehicle height offset calibration |
- |
| HV Ready* | - | - | - |
| TD Terminal | TD terminal / ON or OFF |
ON: Height control is not operating OFF: Height control is operating |
- |
| TC Terminal | TC terminal / ON or OFF |
ON: DTC is output OFF: DTC is not output |
- |
| TS Terminal | TS terminal / ON or OFF |
ON: During test mode OFF: Normal mode |
- |
| IG Power Source Voltage | ECU power supply voltage / min.: 0.0 V max.: 25.5 V |
Engine switch on (IG): 11 to 14 V | - |
| Steering Angle | Steering angle sensor reading / min.: -49152.0 deg max. 49150.5 deg |
Actual steering angle Left turn: reading increases Right turn: reading decreases |
- |
| Engine Speed | Cam position sensor reading / min.: 0 rpm max.: 25,500 rpm |
Actual engine speed | Speed indicated on the combination meter |
| FR Wheel Speed | Front right wheel speed reading / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter |
| FL Wheel Speed | Front left wheel speed reading / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter |
| RR Wheel Speed | Rear right wheel speed reading / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter |
| RL Wheel Speed | Rear left wheel speed reading / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) |
Actual vehicle speed | Speed indicated on the combination meter |
| Damper Step FR | Damper step (Front RH) / min.: 1 step max.: 255 step |
min.: 1 step max.: 17 step |
- |
| Damper Step FL | Damper step (Front LH) / min.: 1 step max.: 255 step |
min.: 1 step max.: 17 step |
- |
| Damper Step RR | Damper step (Rear RH) / min.: 1 step max.: 255 step |
min.: 1 step max.: 17 step |
- |
| Damper Step RL | Damper step (Rear LH) / min.: 1 step max.: 255 step |
min.: 1 step max.: 17 step |
- |
| Max Damper Step FR | Damper step (Front LH) / min.: 0 step max.: 255 step |
17 step | - |
| Max Damper Step FL | Damper step (Front LH) / min.: 0 step max.: 255 step |
17 step | - |
| Max Damper Step RR | Damper step (Rear RH) / min.: 0 step max.: 255 step |
17 step | - |
| Max Damper Step RL | Damper step (Rear LH) / min.: 0 step max.: 255 step |
17 step | - |
| Compatible Constant Information | Information used to change the compatible constant min.: 0 max.: 255 |
- | - |
| Identical Constant Information | Information used to change the identical constant min.: 0 max.: 255 |
- | - |
| Design Constant Information | Information used to change the design constant min.: 0 max.: 255 |
- | - |
| Number of Trouble Codes | Number of DTC recorded / min.: 0 max.: 255 |
0 | - |
Tech Tips
*: This item is displayed on the Techstream, however, it is not used for this vehicle.
Enter the following menus:
Select: Body / Center Console Switch / Data List /
Read the Data List by following the directions on the tester screen.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| HEIGHT HIGH Switch | Height control switch / ON or OFF |
ON: Switch is pressed and held OFF: Switch is not pressed |
- |
| SPORT Mode Switch | Drive mode select switch "SPORT S+" mode / ON or OFF |
ON: Switch turned right and held OFF: Switch is not turned |
- |
| COMFORT Mode Switch | Drive mode select switch "COMFORT" mode / ON or OFF |
ON: Switch turned left and held OFF: Switch is not turned |
- |
PERFORM ACTIVE TEST
Tech Tips
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnosis time. Data List information can be displayed while performing Active Tests.
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and the tester ON.
Enter the following menus:
Select: Chassis / Air suspension / Active Test /
Perform the Active Test by following the prompts on the tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Damper Step FR | Changes damper step (Front RH) / | min.: 1 step max.: 17 step |
Shock absorber hardens as damper step increases |
| Damper Step FL | Changes damper step (Front LH) / | min.: 1 step max.: 17 step |
Shock absorber hardens as damper step increases |
| Damper Step RR | Changes damper step (Rear RH) / | min.: 1 step max.: 17 step |
Shock absorber hardens as damper step increases |
| Damper Step RL | Changes damper step (Rear LH) / | min.: 1 step max.: 17 step |
Shock absorber hardens as damper step increases |
| FR Wheel Up/Down | Right front vehicle height / | UP or DOWN | - |
| FL Wheel Up/Down | Left front vehicle height / | UP or DOWN | - |
| RR Wheel Up/Down | Right rear vehicle height / | UP or DOWN | - |
| RL Wheel Up/Down | Left rear vehicle height / | UP or DOWN | - |
| Front Right Solenoid | Turn OFF front solenoid valve RH 1 second after turning it ON | - | Operation of solenoid (clicking sound) can be heard |
| Front Left Solenoid | Turn OFF front solenoid valve LH 1 second after turning it ON | - | Operation of solenoid (clicking sound) can be heard |
| Rear Right Solenoid | Turn OFF rear solenoid valve RH 1 second after turning it ON | - | Operation of solenoid (clicking sound) can be heard |
| Rear Left Solenoid | Turn OFF rear solenoid valve LH 1 second after turning it ON | - | Operation of solenoid (clicking sound) can be heard |
| Motor Relay | Suspension control relay / | ON or OFF | Operation of solenoid (clicking sound) can be heard |
| Exhaust Solenoid | Exhaust solenoid / | ON or OFF | Operation of solenoid (clicking sound) can be heard |