TRANSFER ASSEMBLY INSPECTION


  1. INSPECT TRANSFER FRONT DRIVE GEAR ASSEMBLY


    1. A01GIPIE01

      Using a micrometer, measure the outer diameter of the drive gear journal surface at the locations indicated.

      Standard outer diameter
      Journal A
      50.981 to 51.000 mm (2.0072 to 2.0078 in.)
      Journal B
      54.461 to 54.480 mm (2.1442 to 2.1448 in.)
      Journal C
      74.461 to 74.480 mm (2.9316 to 2.9322 in.)
      Minimum outer diameter
      Journal A
      50.981 mm (2.0072 in.)
      Journal B
      54.461 mm (2.1442 in.)
      Journal C
      74.461 mm (2.9316 in.)

      • If the outer diameter is less than the minimum, replace the drive gear.

  2. INSPECT TRANSFER INPUT SHAFT


    1. A01GJYZE01

      Using a micrometer, measure the outer diameter of the transfer input shaft journal surface at the locations indicated.

      Standard outer diameter
      Journal A
      47.975 to 48.000 mm (1.8888 to 1.8897 in.)
      Journal B
      50.750 to 50.870 mm (1.9981 to 2.0027 in.)
      Journal C
      34.961 to 34.986 mm (1.3765 to 1.3774 in.)
      Journal D
      17.980 to 18.000 mm (0.7079 to 0.7086 in.)
      Minimum outer diameter
      Journal A
      47.975 mm (1.8888 in.)
      Journal B
      50.750 mm (1.9981 in.)
      Journal C
      34.961 mm (1.3765 in.)
      Journal D
      17.980 mm (0.7079 in.)

      • If the outer diameter is less than the minimum, replace the transfer input shaft.