FRONT PROPELLER SHAFT ASSEMBLY INSTALLATION


  1. TEMPORARILY INSTALL FRONT PROPELLER SHAFT ASSEMBLY


    1. Completely remove any oil or the like and clean the constant velocity universal joint washers and the contact surfaces of the front propeller shaft assembly, transfer and front differential.

    2. A01GKYSE04
      Text in Illustration
      *a Matchmark

      Align the matchmarks on the differential companion flange and front propeller shaft.

    3. Temporarily install the front propeller shaft with 6 new bolts and the 2 universal joint washers.

    4. A01GIQ5E03
      Text in Illustration
      *a Matchmark

      Align the matchmarks on the transfer companion flange and front propeller shaft.

    5. Temporarily install the front propeller shaft with 6 new bolts and the 2 universal joint washers.

  2. INSTALL REAR ENGINE MOUNTING MEMBER


    1. Set the rear No. 3 engine mounting insulator to the rear engine mounting member.

    2. A01GNTQ

      Temporarily install the rear engine mounting member to the automatic transmission assembly with the 5 nuts.

    3. A01GJEU

      Install the rear engine mounting member with the 4 bolts.

      Torque:
      35 N*m  { 354 kgf*cm, 26 ft.*lbf }
    4. A01GHYR

      Tighten the 5 nuts.

      Torque:
      38 N*m  { 387 kgf*cm, 28 ft.*lbf }

  3. TIGHTEN FRONT PROPELLER SHAFT ASSEMBLY


    1. Using a 6 mm socket hexagon wrench, tighten the front propeller shaft with the 6 bolts.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      Be careful not to damage the front propeller shaft.

    2. Using a 6 mm socket hexagon wrench, tighten the front propeller shaft with the 6 bolts.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      Be careful not to damage the front propeller shaft.

  4. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    Click here

  5. INSPECT FOR EXHAUST GAS LEAK