PROPELLER SHAFT ASSEMBLY DISASSEMBLY


  1. REMOVE PROPELLER INTERMEDIATE SHAFT


    1. A01GMR4E08
      Text in Illustration
      *a Matchmark

      Put matchmarks on the intermediate shaft and propeller shaft.

    2. Separate the intermediate shaft and propeller shaft.

      Note

      Be careful not to damage the spline.

    3. Remove the adjusting nut from the intermediate shaft.

    4. A01GKRUE08
      Text in Illustration
      *1 Protective Tape

      Remove the dust boot from the propeller shaft.

      Tech Tips

      If the dust boot is to be reused, remove it after wrapping protective tape around the spline, so it will not be damaged.

  2. REMOVE NO. 1 CENTER SUPPORT BEARING ASSEMBLY


    1. A01GNWT

      Using a snap ring expander, remove the snap ring.

    2. A01GMUNE01

      Using SST and a press, press out the center support bearing and No. 2 dust deflector.

      SST
      09950-00020
    3. A01GMPTE05

      Using SST and a press, press out the No. 1 dust deflector.

      SST
      09950-00020