FLOOR SHIFT ASSEMBLY ADJUSTMENT


  1. ADJUST SHIFT LEVER POSITION


    1. A01GKJV

      Remove the nut and disconnect the floor shift gear shifting rod sub-assembly.

    2. A01GIOEE01

      Turn the control shaft lever of the park/neutral position switch counterclockwise until it stops, and turn it clockwise 2 notches to set it to N.

    3. Move the shift lever to N and tighten the nut while lightly pushing the lever toward R.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

      Note

      Do not push the shift lever too hard.

    4. Check that the shift lever moves smoothly and the shift lever and gear operate correctly.