AUTOMATIC TRANSMISSION SYSTEM DTC CHECK / CLEAR


  1. CHECK DTC


    1. DTCs which are stored in the TCM can be displayed on the intelligent tester.

      The intelligent tester can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in consecutive driving cycles. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the engine switch on (IG) and push the intelligent tester ON.

      3. Enter the following menus: Powertrain / ECT / DTC.

      4. Confirm the DTCs and freeze frame data, and then write them down.

      5. Confirm the details of the DTCs Click here.

        Note

        When simulating a symptom with the scan tool to check for DTCs, use normal mode. For codes on the DIAGNOSTIC TROUBLE CODE CHART subject to "2 trip detection logic", perform the following actions.

        Turn the engine switch off after the symptom is simulated once. Then repeat the simulation process. When the symptom has been simulated twice, the MIL illuminates and the DTCs are recorded in the TCM.

  2. CLEAR DTC (using an intelligent tester)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG) and push the intelligent tester ON.

    3. Enter the following menus: Powertrain / ECT / DTC / Clear.

  3. CLEAR DTC (without using an intelligent tester)


    1. Perform either one of the following operations.


      1. Disconnect the negative battery cable for more than 1 minute.

      2. Remove the EFI MAIN2 fuse from the No. 2 engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.