STARTER (for 2WD) INSTALLATION


  1. INSTALL FLYWHEEL HOUSING SIDE COVER

  2. INSTALL STARTER ASSEMBLY


    1. A01GL91E01

      Connect the starter connector.

    2. Connect the starter wire with the 2 nuts.

      Torque:
      for nut A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      for nut B
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. Close the terminal cap.

    4. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Make sure the flywheel housing side cover is as shown in the illustration.

      A01GLEO

  3. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR


    1. Install the No. 3 exhaust manifold heat insulator with the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL COWL TOP VENTILATOR LOUVER


    1. A01GM4S

      for LHD:

      Install the 6 clips and cowl top ventilator louver RH.

      Note

      If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver RH is installed properly.

    2. A01GI9P

      for RHD:

      Install the 6 clips and cowl top ventilator louver LH.

      Note

      If the cowl top ventilator louver LH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore, make sure the cowl top ventilator louver LH is installed properly.