ENTRY AND START SYSTEM, Diagnostic DTC:B2289

DTC Code DTC Name
B2289 Key Collation Waiting Time Over

DESCRIPTION

This DTC is output when there is a LIN communication problem between the main body ECU and certification ECU or when there is a problem in the engine immobiliser system.

DTC Code Detection Condition Trouble Area
B2289

Either of following conditions is met:


  • Communication or communication line is abnormal among main body ECU, certification ECU, steering lock ECU and ID code box

  • Immobiliser system malfunctions

  • Main body ECU

  • Engine immobiliser system

  • Harness or connector

  • Engine switch

  • Entry function

  • Key
A01GHTLE01

WIRING DIAGRAM

A01GKDBE05

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK DTC


    1. Delete the DTCs Click here.

    2. Check for DTCs again.

      OK
      DTC is not output.

    OK

    END (SYSTEM OK)

    NG

  2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU)

    A01GKQAE01

    1. Disconnect the DA main body ECU connector.

    2. Disconnect the L15 certification ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      DA-52 (LIN1) - L15-10 (LIN) Always Below 1 Ω
      DA-52 (LIN1) or L15-10 (LIN) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK MAIN BODY ECU (OPERATION)


    1. Temporarily replace the main body ECU with a new or normally functioning one.

    2. Check for DTCs again.

      OK
      DTC is not output.

    NG

    GO TO ENTRY AND START SYSTEM (ROOM OSCILLATOR DOES NOT RECOGNIZE KEY) Click here

    OK

    END (MAIN BODY ECU IS FAULTY)