OIL LEVEL SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01GK3K

      Remove the 13 screws, 7 clips and No. 1 engine under cover.

  2. REMOVE NO. 2 ENGINE UNDER COVER


    1. A01GNYR

      Remove the 8 bolts and No. 2 engine under cover.

  3. REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER


    1. A01GM9J

      Remove the 8 bolts and front suspension member protector lower.

  4. DRAIN ENGINE OIL


    1. A01GISB

      Open the oil filler cap service hole cover.

    2. Remove the oil filler cap.

    3. Remove the oil pan drain plug and drain the engine oil into a container.

    4. Install a new gasket and the oil pan drain plug.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  5. DISCONNECT OIL COOLER TUBE


    1. A01GNTA

      Remove the 2 bolts and 2 clamps to disconnect the No. 1 oil cooler inlet tube and No. 1 oil cooler outlet tube.

  6. REMOVE CRANK POSITION SENSOR BRACKET


    1. A01GMY0

      Using a clip remover, disconnect the harness clamp.

    2. Remove the bolt and crank position sensor bracket.

  7. REMOVE ENGINE OIL LEVEL SENSOR


    1. A01GIMM

      Disconnect the engine oil level sensor connector.

    2. Remove the 4 bolts.

    3. A01GNFY

      Rotate the engine oil level sensor 180° and remove it.

    4. A01GHRLE02

      Cut off the gasket as shown in the illustration.

    5. Remove the gasket from the oil level sensor.

      Tech Tips

      After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.